Nta
■ High-density architecture with 4,608 to 68,416 LEs
● M4K embedded memory blocks
● Up to 1.1 Mbits of RAM available without reducing available logic
● 4,096 memory bits per block (4,608 bits per block including 512 parity bits)
● Variable port configurations of 1, 2, 4, 8, 9, 16, 18, 32, and 36
● True dual-port (one read and one write, two reads, or two writes) operation for 1, 2, 4, 8, 9, 16, and 18 modes
● Byte enables for data input masking during writes
● Up to 260-MHz operation
Embedded multipliers
● Up to 150 18- 18-bit multipliers are each configurable as two independent 9- 9-bit multipliers with up to 250-MHz performance
● Optional input and output registers
Advanced I/O kev them nyiaj yug
● High-speed differential I/O standard support, including LVDS, RSDS, mini-LVDS, LVPECL, differential HSTL, and differential SSTL
● Single{{0}}ended I/O standard support, including 2.5-V and 1.8-V, SSTL class I and II, 1.8-V and 1.5-V HSTL class I and II, 3.3-V PCI and PCI-X 1.0, 3.3-, 2.5-, 1.8-, and 1.5-V LVCMOS, and 3.3-, 2.5-, and 1.8-V LVTTL
● Peripheral Component Interconnect Special Interest Group (PCI SIG) PCI Local Bus Specification, Revision 3.0 compliance for 3.3-V operation at 33 or 66 MHz for 32- or 64-bit interfaces
● PCI Express with an external TI PHY and an Altera PCI Express 1 Megacore® function
● 133-MHz PCI-X 1.0 specification compatibility
● High-speed external memory support, including DDR, DDR2, and SDR SDRAM, and QDRII SRAM supported by drop in Altera IP MegaCore functions for ease of use
● Three dedicated registers per I/O element (IOE): one input register, one output register, and one output-enable register
● Programmable bus-hold feature
● Programmable output drive strength feature
● Programmable delays from the pin to the IOE or logic array
● I/O bank grouping for unique VCCIO and/or VREF bank settings
● MultiVolt™ I/O standard support for 1.5-, 1.8-, 2.5-, and 3.3-interfaces
● Hot-socketing operation support
● Tri-state with weak pull-up on I/O pins before and during configuration
● Programmable open-drain outputs
● Series on-chip termination support
Flexible moos tswj circuitry
● Hierarchical clock network for up to 402.5-MHz performance
● Up to four PLLs per device provide clock multiplication and division, phase shifting, programmable duty cycle, and external clock outputs, allowing system-level clock management and skew control
● Up to 16 global clock lines in the global clock network that drive throughout the entire device
Ntaus configuration
● Fast serial configuration allows configuration times less than 100 ms
● Decompression feature allows for smaller programming file storage and faster configuration times
● Supports multiple configuration modes: active serial, passive serial, and JTAG-based configuration
● Supports configuration through low-cost serial configuration devices
● Device configuration supports multiple voltages (either 3.3, 2.5, or 1.8 V)
Cov cuab yeej cuab tam
● Altera megafunction and Altera MegaCore function support, and Altera Megafunctions Partners Program (AMPPSM) megafunction support, for a wide range of embedded processors, on-chip and off-chip interfaces, peripheral functions, DSP functions, and communications functions and protocols. Visit the Altera IPMegaStore at www.altera.com to download IP MegaCore functions.
● Nios II Embedded Processor support
Cim npe nrov: ep1c6t144c8n, Tuam Tshoj, lwm tus neeg, manufacturers, lag luam wholesale, hauv Tshuag
